Australian Capital Territory Numbered Regulations

ROAD TRANSPORT (MASS, DIMENSIONS AND LOADING) REGULATION 2010 (NO 4 OF 2010) - REG 31

    (1)     The road transport authority may, on application by a person, issue the person a permit (a class 3 permit )—

        (a)     exempting a stated class 3 vehicle from—

              (i)     a mass or dimension requirement mentioned in schedule 1 (Mass and loading requirements for heavy vehicles), other than a requirement about a GVM, GCM or manufacturer's limit; or

Note     Mass and dimension requirements about a GVM, GCM or manufacturer's limit are mentioned in sch 1, div 1.1.1 and s 1.8.

              (ii)     a dimension limit mentioned in the Road Transport (Vehicle Registration) Regulation 2000 ; or

Note     Dimension limits are mentioned in the Road Transport (Vehicle Registration) Regulation 2000 , s 163 and sch 1.

        (b)     to operate a stated class 3 vehicle in a stated area, or on a stated route, not included in a class 3 notice.

Note 1     If a form is approved under the Road Transport (General) Act 1999 , s 225 for this provision, the form must be used.

Note 2     A fee may be determined under the Road Transport (General) Act 1999 , s 96 for this provision.

    (2)     A class 3 permit may be conditional.

Note 1     Section 33 sets out conditions to which some class 3 permits may be subject.

Note 2     It is an offence to drive a vehicle or combination that is subject to a permit without carrying a copy of the permit (see s 67).